HEAD LAMP/TURN SIGNAL LAMP
| 1. |
Disconnect the negative battery
terminal. |
| 2. |
Remove the front bumper upper
cover.
|
| 3. |
Remove the head lamp and turn signal lamp
mounting bolts (3EA) and remove the lamp assembly.
|
| 4. |
Installation is the reverse of
removal. |
FRONT FOG LAMP
| 1. |
Disconnect the negative battery
terminal. |
| 2. |
Remove the turn signal lamp and head lamp
assembly.
|
| 3. |
Remove the front bumper cover (Refer to BD
group).
Disconnect the wire connector and remove the
front fog lamp.
|
| 4. |
Installation is the reverse of
removal. |
REAR COMBINATION LAMP
| 1. |
Disconnect the negative battery
terminal. |
| 2. |
Remove the luggage trim side
cover. |
| 3. |
Remove the 3 screws holding the rear
combination lamp and disconnect the wire connectors.
|
| 4. |
Remove the rear combination lamp
assembly.
|
| 5. |
Installation is the reverse of
removal. |
CENTER HIGH MOUNTED STOP LAMP
| 1. |
Disconnect the negative battery
terminal. |
| 2. |
Remove the rear spoiler after removing 4 nuts.
(External spoiler type) |
| 3. |
Remove the center high mounted stop lamp
assembly. |
| 4. |
Installation is the reverse of
removal. |
LICENSE PLATE LAMP
| 1. |
Disconnect the negative battery
terminal. |
| 2. |
Remove the mounting screws and disconnect the
lamp connector. |
| 3. |
Installation is the reverse of
removal. |
OVERHEAD CONSOLE LAMP
| 1. |
Disconnect the negative battery
terminal. |
| 2. |
Detach the map lamp lens from the lamp
assembly with a flat-tip
screwdriver. |
| 3. |
Detach the lamp assembly from the headliner
after removing the 4 screws.
|
| 4. |
Disconnect the wiring connectors from the
headliner.
|
| 5. |
Installation is the reverse of
removal. |
LUGGAGE LAMP
| 1. |
Disconnect the negative battery
terminal. |
| 2. |
Detach the luggage lamp assembly from the
luggage side trim with a flat-tip
screwdriver. |
| 1. |
Installation is the reverse of
removal. |
HEAD LAMP RELAY
| 1. |
Remove the head lamp relay from the relay box
in the engine compartment. |
| 2. |
Check for continuity between terminals on the
relay. |
HAZARD SWITCH
| 1. |
Disconnect the negative (-) battery
terminal. |
| 2. |
Remove the center facia panel with a flat-tip
screwdriver.
|
| 3. |
Detach the hazard lamp switch from the center
facia panel. |
| 1. |
Operate the switch and check for continuity
between terminals with an ohmmeter. |
RHEOSTAT
| 1. |
Disconnect the negative (-) battery
terminal. |
| 2. |
Disconnect the rheostat connector from the
crash pad panel. |
| 1. |
Check for intensity. If the light intensity of
the lamps changes smoothly without any flickering when the rheostat
is turned, it can be assumed that the rheostat is
normal.
|
FRONT FOG LAMP SWITCH
| 1. |
Disconnect the negative (-) battery
terminal. |
| 2. |
Detach the switch connector from the center
facia panel. |
| 1. |
Operate the switch and check for continuity
between the terminals with an ohmmeter.
|
MAP LAMP SWITCH
